This 20kw Generac generator provides nearly all the backup power needed to run the whole house.
Author: EricW
20kw generac generator graham, wa
The 20 killowatt model 6244 standby generator is ready for action. Our 500 gallon tank will provide days of run time for the long outages that sometimes occur. On the day we installed this generator the power was out when we arrived. We later heard that there was faulty utility...
How to change standby generator oil renton, wa
By following a few simple steps changing the oil is not difficult. -run the engine for a few minutes to allow the oil to drain more easily -use Generac branded filters that will ensure proper fit and function -Do not over fill the oil as this can lead to premature...
11kw generator redmond, wa
We found a nice place to install the generator away from the house a little ways, and adjacent to the fence.
11kw home standby generator North Bend, WA
We were able to feed this generator from the existing LP gas supply The new transfer switch panel was installed next to the main panel in the garage.
Normandy park 11kw standby generator
Nice recessed indtallation Gas and electrical lines were trenched below ground.
14kw standby generator installation Buckley, WA
This generator is connected to the customers LP gas tank. Buckley, WA came out to test the gas line for leaks. We chose to install a Gen ready load center for a nice clean looking installation.
20kw Sammamish, WA standby generator installation
This will power up the whole house (managed loads) in Samammish, WA With mobile link this customer can monitor generator usage and always know if the Miniture "power plant" is ready for the next outage.
20kw standby generator Redmond, wa
We found a nice spot along side the garage for this automatic standby generator. Because this Window doesn't open we were able to place it closer than the normal 5 feet allowed to Windows and doors. Pse has been contacted and had schedule a has a meter and line upgrade...
20kw Generac generator Fall city, wa
This 20kw generator was located on the side of the garage. We maintained our setbacks with no problems. We tied into the main panel with a 200amp transfer switch. Our gas meter was tied in with 1 1/4" gas line to feed the generator. Our gas inspector inspected the system...